Back to PLS HelpPLS generated files for Seed
Posted on 03/07/08 16:10:28
Number of posts: 9
Hi Jimmy,
I have all the PLS generated files (I assume you didn't need the raw test data). It would be wonderful if you can see what I am doing wrong with running the seed analysis. Included are the session, result, and datamat files. also the multivoxel extraction and cluster reports. The cluster report So you can get the files from.
ftp.fmri.org
Username = guest
Password = guest*
The files are in the folder mumali.
Have a great weekend,
Michelle
I have all the PLS generated files (I assume you didn't need the raw test data). It would be wonderful if you can see what I am doing wrong with running the seed analysis. Included are the session, result, and datamat files. also the multivoxel extraction and cluster reports. The cluster report So you can get the files from.
ftp.fmri.org
Username = guest
Password = guest*
The files are in the folder mumali.
Have a great weekend,
Michelle
Replies:
Untitled Post
I'm Online
Posted on 03/07/08 17:54:45
Number of posts: 291
In order to run Behavior PLS (Seed PLS uses Behavior PLS), you will need at least 3 subjects.
You can find this from:
http://www.rotman-baycrest.on.ca/pls/UserGuide.htm
under Figure 17
You can also find this from:
http://www.rotman-baycrest.on.ca/index.php?section=483
and here is the extraction:
You can find this from:
http://www.rotman-baycrest.on.ca/pls/UserGuide.htm
under Figure 17
You can also find this from:
http://www.rotman-baycrest.on.ca/index.php?section=483
and here is the extraction:
Q: I got "divide by zero" error when I tried to run Behavior PLS
analysis, while there is no error when I ran task PLS.
A: There are two reasons that could bring you into this trouble:
1. You must have at least 3 subjects to do the behavior PLS.
2. Values should not be all the same for behavior data. Even
if they are really all the same, you must add (or minus) a
slight difference (e.g. 1/1000) to make it work.
Login to reply to this topic.
